Grip OD Caliper · Standard vs. Midsize · +1/64" Tape-Wrap Math

Grip diameter & wraps.
Quiet your hands at impact.

Grips that are too thin make your fingers dig in and flip the face shut; grips too thick block release to the right. Use Club Carry (clubcarry.com) to convert wrist-to-fingertip length into exact grip size, extra build-up tape wraps, and swingweight balance.

Standard (0.900")
7.0"–7.6" hand
Midsize (+1/16")
7.7"–8.7" (= +4 wraps)
Jumbo (+1/8")
8.8"+ (= +8 wraps)
Quick Verdict · Updated Nov 2026

Measure from your wrist crease to middle fingertip: <7.0" fits Undersize, 7.0"–7.6" fits Standard (0.900"), 7.7"–8.7" fits Midsize (+1/16" / 0.960"), and 8.8"+ fits Jumbo (+1/8" / 1.020"). Each extra layer of build-up tape adds +1/64" (+0.015"), so Standard + 4 extra wraps equals Midsize OD without adding 13g of rubber butt weight.

01 · Hand & release profile
8.2 in (20.8 cm)
3.5 in (8.9 cm)
04 · Ball-Flight Tendency / Feel Goal
Grip Cross-Section & Build-Up Recipe Midsize (+1/16" · 0.960" OD)
8.2 in Hand · 3.5 in Finger · Neutral Fit
Fitted Grip Spec Midsize 0.960" OD (+1/16" vs. Std)
Shop Tape Recipe Std + 4 Wraps Or 1 Midsize grip + 1 base tape
Swingweight Shift -2.5 pts ~63g Midsize vs. 50g Standard

01

HAND LENGTH & GLOVE CHART

Golf grip size chart by hand length, glove size & OD.

Click any hand-length row below to load its exact build-up tape recipe and caliper diameter above:

Golf grip sizes measured 2 inches below butt cap (.600 core on .600 butt shaft)
Wrist-to-Finger Typical Glove Grip Size Diameter (OD) Load
Under 7.0" (<17.8 cm) Women’s S–M / Men’s S Undersize 0.850"–0.870" (-1/32")
7.0"–7.6" (17.8–19.3 cm) Men’s M / Cadet M-L Standard 0.900"–0.915" (0 to +1 wrap)
7.7"–8.7" (19.6–22.1 cm) Men’s L – XL Midsize (+1/16") 0.960" (= Std + 4 wraps)
8.8"+ (22.4+ cm) Men’s 2XL – 3XL Jumbo (+1/8") 1.020" (= Midsize + 4 wraps)
02

PRO-SHOP BUILD SECRETS

Midsize grip vs. Standard + 4 wraps: why tour pros care.

  • Firmness vs. Cushion: Stretching a 50g Standard grip over 4 extra wraps of build-up tape creates the exact same 0.960" Midsize diameter—but stretches the rubber taut for firmer cord feedback, whereas a factory Midsize grip uses thicker, softer rubber walls.
  • Butt Weight & Swingweight: A factory Midsize grip adds ~13g at the handle (lowering scale swingweight ~2.5 points), while 4 wraps of masking tape add only ~5.5g.
  • Reduced-Taper (“+4” Lower Hand) Grips: If your top hand fits Standard/Midsize comfortably, but your trail right hand squeezes too tightly on wedges and short irons, play a reduced-taper “Plus 4” profile (simulating 4 extra wraps under the bottom hand only!).
03

GRIP FITTING FAQ

Common golf grip size questions.

What is the finger-touch test on a golf club grip?

Take your normal lead-hand grip: the tips of your middle and ring fingers should lightly brush or sit ~1–2 mm shy of your thumb pad. If your fingernails dig hard into your palm, the grip is too thin; if there is a wide 1/2-inch gap, the grip is too thick (unless intentionally playing non-tapered jumbo grips).

What is the difference between .580 and .600 core golf grips?

Putting a tighter .580 core grip onto a standard .600 butt shaft stretches the rubber slightly outward—automatically making the finished grip play +1/64" (+1 wrap) thicker without adding extra masking tape!

How often should you replace golf grips?

Every 40 rounds or once a year (whichever comes first). UV light, sweat, and skin oils harden rubber compounds—forcing you to squeeze 20–30% tighter just to keep the club from twisting on off-center strikes (see off-center smash loss).