14-Inch Lorythmic Fulcrum · D0–D6 Head Feel · Lead-Tape Math

Swingweight & lead tape.
Dial in head feel at impact.

Trimming 0.50" off your driver or installing Midsize grips silently strips 3 to 5.5 swingweight points—making the clubhead disappear at the top of your backswing. Use Club Carry (clubcarry.com) to compute exact C6–E2 shifts and lead-tape restoration.

±0.50" shaft length
±3.0 SW points
~2g head weight
+1.0 SW point
+5g heavier grip
-1.0 SW point (butt)
Quick Verdict · Updated Nov 2026

On a standard 14-inch Lorythmic fulcrum scale, 1 swingweight point equals ~2g at the clubhead (1.8g Driver, 2.0g Iron, 2.2g Wedge), 0.17" of shaft length (±3 pts per 0.50"), -5g of grip weight, or 9g of shaft weight. Standard benchmarks: D2–D4 Drivers, D1–D3 Irons, and D4–D6 Wedges.

01 · Build modifications
02 · Club category (calibrates lever arm)
D3 (Baseline)
-0.50" (-3.0 pts)
0 g (+0.0 pts)
+13 g (-2.6 pts)
0 g (+0.0 pts)

14-Inch Fulcrum Balance & Lead Tape

C7.4 · -5.6 pts
DRIVER / WOODS · START D3 → C7.4
Baseline: D3 · Target Window: D2–D4 Tour/Stock Live Scale: C7.4 (True Head Feel -3.0 pts)
New Swingweight C7.4 From D3 (D2–D4 Tour/Stock)
Net Scale Shift -5.6 pts Includes -2.6 pt grip shift
To Restore Target +10g at Head 10" HD tape (or 20" std 0.5g/in)

01

CLUBBUILDING EQUIVALENTS

Golf swingweight rules of thumb & stock club benchmarks.

Click any build scenario below to load its exact gram and inch numbers into the fulcrum calculator above:

Standard swingweight bands and common modification impacts across Driver, Irons, and Wedges
Club / Modification Stock Band 1 SW Point Equals Typical Fix Test
Driver cut -0.50" (45.5"→45.0") D2–D4 1.8g head / 0.17" len Swap +6g heavier rear head screw
Men’s Irons (4i–9i) D1–D3 2.0g head / 9g shaft 2g brass tip weight during shaft epoxy
+0.50" Over-Length Irons D5 without light heads +3.0 pts per +0.50" Order OEM “B-weight” (-6g lighter) heads
Sand & Lob Wedges (54°–60°) D4–D6 2.2g head / 4" std tape Keep heavier so head drops cleanly through sand
02

COUNTERBALANCING TRAP

Why you shouldn’t blindly add lead tape after installing Midsize grips.

Because a Lorythmic scale pivots 14 inches from the grip cap, adding a 63g Midsize grip (+13g heavier than a 50g Standard grip) pulls the butt end down and makes the scale read ~2.6 points lighter (e.g., D3 reads D0.4):

  • Head mass hasn’t changed: Your hands actually sit on top of the 14-inch fulcrum, so the clubhead rarely feels 3 points lighter in real swings (see grip size & tape-wrap math).
  • Test before taping: Only add head weight when you shorten shaft length or switch to a much lighter shaft—adding 6g at the head just to please a scale after regripping raises total club weight by nearly 20 grams!
03

SWINGWEIGHT FAQ

Common golf swingweight & lead tape questions.

How many inches of lead tape equal 1 swingweight point?

Standard 1/2-inch golf lead tape weighs 0.5 grams per inch, so 4 inches (~2g) adds +1 swingweight point. High-density 1/2-inch lead tape weighs 1.0 gram per inch, needing just 2 inches (~2g) per swingweight point.

Does adding 4g of lead tape change ball flight or draw/fade bias?

Adding 2g to 6g of lead tape changes dynamic clubhead feel and release timing far more than center-of-gravity physics (it takes ~12g–15g to shift internal CG enough to move gear-effect spin directly)—though placing tape on the heel or rear perimeter subtly aids closure or MOI.

What is the difference between Swingweight and MOI matching?

Traditional swingweight matches balance around a 14-inch fulcrum (typically D2 across 4i–9i), which leaves longer irons slightly harder to swing than short irons. MOI matching progressively trims ~0.5 swingweight point per club upward so every iron requires identical rotational effort.